MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks! 

icon
Avatar
andykap
Posts: 3
Hi All,

I am having the hardest time to to setup the landing gear with my home cockpit.

I am using Jeehell v49.1 P3D4.1
My MF setup for the landing gear is as follows:

Two micro switches, 1 for UP the other for Down.

MF Gear UP config - 0x0BE8 - INT bytes 4 - Set Value 0

Gear down - 0x0BE8 - INT bytes 4 - Set Value 16383. I tried 1 & 2.

Is this correct? If not what should I be using?

Thanks in advance.

Richard
2017-12-30 18:11
Avatar
andykap
Posts: 3
After reading the advance user guide, there it was. The values are as follows: 78ED - 1 - 81 - up / 82 down

Now I have this issue where when I press the button, the gear starts to go down then it stop. Is there a solution for that?
2017-12-31 17:15
Avatar
pizman82
Moderator
From: ETSI, Germany
Posts: 2916
Supporter
Please look at that topic !
https://www.mobiflight.com/forum/message/7130.html

I not own Jeehell FMGS but it look like a problem in the new release , and the communication with FSUIPC.

Please if possible check that your FSUIPC is on the newest Version UptoDate.


If i´m right, check the jeehell suport forum and please report if this situation is solved by jeehell.
Good Luck !
2018-01-01 09:59
Avatar
andykap
Posts: 3
I found the problem was with the Mega board I was using. It is defective. I replace it with another that I have and all is well.
2018-01-04 18:45
Avatar
pizman82
Moderator
From: ETSI, Germany
Posts: 2916
Supporter
Nice to hear it workes....
But Please not throw the Mega in the trash !!

Its extremly rare that a Mega is broke.... In lots of cases there was just a issue in the firmware or sketch maby.... You can try to reset the Mega and delete the Mobiflight firmware manualy..... Then Flash it again and check if it work now.

If it´s realy broke then ok.... But maby you can use it in the future, too !
Good Luck !
2018-01-05 01:50
icon