MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #7124

andykap

Posts: 3

Hi All,

I am having the hardest time to to setup the landing gear with my home cockpit.

I am using Jeehell v49.1 P3D4.1
My MF setup for the landing gear is as follows:

Two micro switches, 1 for UP the other for Down.

MF Gear UP config - 0x0BE8 - INT bytes 4 - Set Value 0

Gear down - 0x0BE8 - INT bytes 4 - Set Value 16383. I tried 1 & 2.

Is this correct? If not what should I be using?

Thanks in advance.

Richard

2017-12-30 18:11

Message #7129

andykap

Posts: 3

After reading the advance user guide, there it was. The values are as follows: 78ED - 1 - 81 - up / 82 down

Now I have this issue where when I press the button, the gear starts to go down then it stop. Is there a solution for that?

2017-12-31 17:15

Message #7131

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

Please look at that topic !
https://www.mobiflight.com/forum/message/7130.html

I not own Jeehell FMGS but it look like a problem in the new release , and the communication with FSUIPC.

Please if possible check that your FSUIPC is on the newest Version UptoDate.

If i´m right, check the jeehell suport forum and please report if this situation is solved by jeehell.

Good Luck !

2018-01-01 09:59

Message #7184

andykap

Posts: 3

I found the problem was with the Mega board I was using. It is defective. I replace it with another that I have and all is well.

2018-01-04 18:45

Message #7187

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

Nice to hear it workes....
But Please not throw the Mega in the trash !!

Its extremly rare that a Mega is broke.... In lots of cases there was just a issue in the firmware or sketch maby.... You can try to reset the Mega and delete the Mobiflight firmware manualy..... Then Flash it again and check if it work now.

If it´s realy broke then ok.... But maby you can use it in the future, too !

Good Luck !

2018-01-05 01:50