MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #27833

Engine10

Posts: 2

Hi Everyone,

I hope you anybody can help me or to give me a good tip?

I have been using VRInsight's MCP Combo II Boeing until recently. But since I am building a homeckpit B777, I am of course trying to buy and install the hardware as realistic as possible

From www.flightsimpm.com I bought the landing gear lever + EFIS + Panelswitch for the B777 and run them all with the Linda software.

Recently I bought a MCP from the company SimTek with a COM Port via RS232 to USB Connection.... As it is very close to the real MCP.

Unfortunately SimTek does not offer any software to the MCP from the company SimTek with a COM Port via RS232 to USB Connection.... As it is very close to the real MCP.

Now comes my question to you

I strongly assume that the Linda software accesses your FSUIPC .Lua and thus the hardware will work in P3d V5.5 ( like the MCP from VRInsight)

I have a PDF file, with the code language of the MCP...! So anybody could read the file with code and I hope anybody can help me to bring this into the P3D V5.4 via FSUIPC?

Or any other idea?
1000 thanks for your answer

Best regards

Stephan

[Last edited by Engine10, 2023-06-07 22:38]

2023-06-07 22:30