MobiFlight Community Support

Hi all,

I am a bit lost with my TBM930 home cockpit, i only have 4 switches left to do before it’s finish but i can’t figure out the problem

So i stil have :

- The “source” switch, it’s a 3 positions on-off-on, suppose to act like that, off-batt-gpu. I use the preset on hubhop, GPU for the on press, batt for release and for the other side Off for the on press and batt for release. When i hit run in MF nothing happen like it doesn’t work.
Tried the debug in MF and the switch is working well, just nothing happen to the sim.

- The “generator” switch, basically the same as source but off-main-stby, for this one i also use preset but here’s only toggle from off to main works.

- the crash bar, connected to a limit switch, works well in debug but nothing happen in the sim with the hubhop preset.

- and last one is the starter switch, it is a on-off-mom switch, but when using the preset, the switch in the sim flick on off very fast but its suppose to stay on starter till i release the mom switch.

Anyone can help ?

Hope this is clear

Thank you in advance

No clue ?

i am still struggling and can't find any solution

Hi

I not use this aircraft. So i can´t tell you if Presets are fine.
E.g. if there was a patch of the Sim maybe still working Presets from last year stop working again.
Also most of Presets are done by users.... We can not confirm if these are correct or if somebody puplish a bugged one untul somebody report a problem.


I recommend.... Join our Discord ! https://discord.gg/99vHbK7
There meanwhile we do most of support.

There are powr users who know to build these Events and Presets and can confirm for you if the work and if not they can create a new working preset for you.

Also via Discord we can do a personal seasson where we can talk and share screen. So i can much better see whats wrong !