MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #23661

Guiche_Bazo

Posts: 1

Hello all,
I'm having problems with last update 9.0.0 and pro micro board...
Stepper motor are no longer working (they were working fine with 8.2) after firmware update it says "upload finish with errors" and it doesn't work.
Need to factory reset it to make it work again but with no stepper.
Inputs and outputs work ok

2021-08-12 02:56

Message #23699

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

Hi

As i know the new features ( Poti and ShiftRegister) enlarge the firmware.
In case also prior the firmware was way to large for the Micro this gain trouble.

May my information is outdated and a new Beta still fix this .... I was not online some days.

My last information was:
Sebastian "try" to downsize the firmware so all is working fine.
If not possible he will release a firmware for the micro with a lower posibility ( e.g. Micro then no longer support one or two features.
As we know most users work with Buttons and Encoders and LED with the Micro so it would be logical to remeove e.g. Stepper, 7Seg , Servo, LCD , Poti or so.
In easy words..... I think we need to loose some elements for the Micro to make it compatible..... As less as possible but as much as needed.

Good Luck !

2021-08-18 13:37

Message #23903

Kaellis991

Posts: 12

The Sparkfun Pro Micro 5v/16 MHz delivered to me today is not recognized by MF connector.

2021-09-17 21:47