MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #22119

echo

Posts: 9

Hi Folks. I am using FSX and XP11. Tuning Com 1 with encoder is working with both sims using offsets. However it is very slow. It takes a lot of turns to change the frequency. This is not practical. Is it possible to use seperate offsets for MHZ and KHZ similar to how it is set up with event ID? I know that event ID will not work with XP. Thanks

2021-02-11 18:49

Message #22128

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

Sure.... You just need to rework your Input Configs.

I not see what formulas you use at the moment.... But pretty sure you increase the Khz.... Means you need to turn 40 Steps to increase from 121.000 to 122.000
If you use another formula like $+100 then it increase by 1 Mhz instead.

But sure
In Offset write it is not so easy !!.... You need pretty sure also a protection for the overdrive. E.g. If Value is 118.000 then a decrease must set to 137.000

Whatever.... This Inputs are a little difficult and advanced. I personaly recommend to use EVENTID in FSX and in Xplane you should think about Keyboard or Joystick Buttons instead.

So... It´s possible with correct formulas.... But its more usefull with the other ways.

Good Luck !

2021-02-12 16:05

Message #22157

echo

Posts: 9

Ok, thanks I will play around with it some more.

2021-02-13 19:47