MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks! 

icon
Avatar
fjgaspar
Posts: 18
Hi,
Today, my Mobiflight has update to 16 release. Also, it has updated my Arduino firmware. Now, every input I have, acts twice. For example, a button assigned to an event, sends the event twice; a rotary assigned to an FSUIPC Offset sends the command twice. So if for example I have a button asigned to parking brakes, sends twice the event, so parking brake is not released. If I have a rotary to set altitude in 100 feet intervals, it increments or decrements in 200.

Is it a bug or how can I solve it?
2021-01-24 19:43
Avatar
fjgaspar
Posts: 18
I don't understand. I have switch off the arduino, restarted Mobiflight and it works perfectly.

Sorry for the alarm.
2021-01-24 20:13
Avatar
pizman82
Moderator
From: ETSI, Germany
Posts: 5571
Supporter
Hi

For the future.....

I use Mobiflight since years and got some simple workflows.....
Technical the follow is all not needed.... And Sebastian always said Mobiflight "should" work without that tricks....
I simply do it all the time and have no problems.... Maybe i do it unless.... But better unless work as a Bug !


-If you UPLOAD something ( Whatever a Device or a new Firmware) to a Board.... always make a Restart of the Mega ( Short Disconnect/Reconnect of USB ) and also restart Mobiflight Software.

- If you create a new Config line, or change a setting in a Config while MF was Running..... Always make a STOP and a RUN behind. So you get sure all changes are active.

- And Run Mobiflight and Sim always in Admin Mode.
Good Luck !
2021-01-25 09:53
icon