MobiFlight Community Support

Hi all

I'm struggling and can't figure this out.

I'd like to play with servo's. But every time I load a servo it seems to bomb out the system.

Here's what happens:
Under the settings I'll follow the steps to add a new module. Upload it to the card, save and go back to Mobiflight. If I go into the configuration wizard, select the flaps as per the example. When I get to the display tab, I select my Mega Module and then when I look under the "Use type" there is nothing there. It's all gone. If I go back to settings, anything and everything I had added is gone, LED's, buttons, encoders, everything is gone.

If I load a saved file, I get everything back except the Servo. I'll save it, check that everything is working 100%. Then when I go add a servo again the same thing happens. It deletes everything off the Module.

Hi

Thats sounds strange !

Please confirm you "upload" the new element (Servo) in settings menu correctly.... After some seconds the "Upload finished" Window have to pop up..... You write you "save" then. Please confirm the upload.... saving is just a backup of the board device configfiles (mfmc file) . To work with an element you have to UPLOAD it.

additional please confirm you got Mobiflight 7.2.3 and new Firmware ( release last days) there was some bugs that fixed with this patch
At last please tell me your specific Board... Uno or Mega ? on Unos maby there are already some bugs.... This support is still new and not tested at all.

If I load a saved file, I get everything back except the Servo. I.

Please tell me WHAT file you load here ? The MFMC File from Device Setting Menu ?? Confusing cause you say before you saved it WITH the Servo (after you create it) .... So it should be included here too ???



Thanks !