MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #19609

izual

Posts: 1

I have been trying to get this to work all day , I am unable to find that the XPUUIPC is for that knob.

I have xplane 11 current version,
arduino Mega 2560
mobiflight installed
rotary encoder
pin 1 to pin 25 , pin 2 from encoder to ground and pin 3 to pin 26 on the arduino mega

setup as encoder,
went to input section of the inputconfigwizard
unable to find preset for the knob.

any information on controlling the knob on the directional instrument would be helpful, its that know you turn to set the heading you want then you can simply hit the autopilot hdg button and stay on course that way.

Thank you,

2020-08-17 00:17

Message #19615

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

Hi

If there is no Preset you must simply search the list for it.
I not use Xplane..... so i can not test for you.

FSX/P3D would be Offset "07CC 2 Autopilot heading value, as degrees*65536/360"

Good Luck !

2020-08-17 11:42