MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks! 

icon
Avatar
Martin
Posts: 27
hy

I use FSX with standard aircraft a320

a simple function with the button appr I select the code 1 appr ON and in release 0 OFF, but when doing it to work it is not a problem but to turn it off option 0 I have to press the button several times until it acts.

can someone help me with the theme

Thank you
2019-02-25 21:01
Avatar
pizman82
Moderator
From: ETSI, Germany
Posts: 3322
Supporter
Hi

Do you use a EventID or a FSUIPC Offset ?

Normaly the APPR Function is a Toggle. This "Button" have no ON or OFF Position.... Its a momentary Toggle Button.
I don´t know Airbus itself cause i use Boeing only.... But it makes no Sense if this is a Latching switch with a OFF Command, cause after catching the LOC/GS the Function switch to OFF..... With a latching Switch that would be not possible to simulate.

Check also these information....

iconQuote:

07FC 4 Autopilot GlideSlope hold
N.B. setting this also sets 0800, approach hold. To clear both you
need to write 0 to them in the same FSUIPC process call, as if
they are separated by an FS frame, an interlock stops them
clearing.


0800 4 Autopilot Approach hold.
See the note above, for offset 07FC.



*****
Solution.... Try to write those 8 Bytes Togeteher ( Not do this myself)
OR
Use Event ID : Try out the follows......
AP APR HOLD 65724 (This should be a Toggle with Parameter 1)

AP APR HOLD ON 65806
AP APR HOLD OFF 65814 (Those two are for ON OFF .... Whatever i not see the logic... You can try out)
Good Luck !
2019-02-26 08:45
Avatar
Martin
Posts: 27
thank you
2019-02-26 21:03
icon