MobiFlight Community Support

Hello Guys,

I have setup a DIY MCP with the following config:

Pins 2 to 26 are buttons
Pins 28 to 44 are leds
Pins 45-47 are 7 seg displays
Pins 48-53 are encoders

All is working great apart from 6 pins. Pins 19,20, 24,25, 50,51

I can see the LED blink on the Ardunio Mega when the button is pressed, but its not registered in the debug screen

If i delete all other pins in the settings page apart from pins 19, 20, 25, 50 & 51 work perfectly. As soon as i add the rest, they stop working.

Is there a reason for this? I am curious if i have too many switches or if there is a better way to setup?

Of course i have spare pins on another board and will just use them, But for the life of me, i can not figure out why the become inoperative.

I do appreciate all the work from the Mobiflight team, Thank you.

Kind Regards

Karl

How are you connecting a potentiometer? where would you put the three pins? In Mobiflight, I would assume I choose the encoder, but now it's asking for two pins, which two should i choose and where does the third pin go?

Again: it is not possible to use MobiFlight with a potentiometer!