MobiFlight Community Support

Bom dia srs: o encoder não funciona v. 7.5.2 no PMDG
Alguém poderia me ajudar?

Olá meu amigo
Por favor, escreva ou traduza suas palavras em inglês

****
Please give us more detail information.

Basicly PMDG is working as before ... also with 7.5.2

If your Encoder not work completly.... Then YOU have a issue. ( PMDG Inputs are tested and 100% funtional ! )

The only reported problem at the moment is a "slow" running of encoders and a "afterun" on inputs.
Here please try to disable "Logging Mode" in Mobiflight and set your FSUIPC Polling Rate to 300 or 400 ms !

******

Please report experience or give more information about your problem !

Good afternoon friends.
when I used the 7.4.0 the encoder works perfect but in version 7.5.2 the encoder does not work in the PMDG

Again... More informations !

7.4 is over 12 months old ..... Version before 7.5.2 was 7.5.0 So if you use 7.4 it is difficult to reproduce your problem.

Also please tell us WHAT is the problem.

when I used the 7.4.0 the encoder works perfect but in version 7.5.2 the encoder does not work in the PMDG

1. "not working" mean it do nothing or just it work "slowly" and not smoothe.
2. Only THIS encoder or all encoders ?
3. Does THIS Encoder work for a standard Aircraft ?
4. Do you patch firmware ? With 7.5 there was a chnge in the encoder setup ( Choose of detent setting )
If your Encoder not work i recommend to delete the device on Mega and then create it new ( with correct detent setting)

All functions are working in 7.5.2, except ex: COURSE L, IAS, HDG, ALT. VS, COURSE R

ex: Encoder
COURSE L

EVENT ID 70008
On Left
PARAMETER -536870912
On Right
PARAMETER +536870912

did you see?

Hi Claudio,

you use the right EventID for Course_L but the wrong parameters.

The Parameter -536870912 does not exist.
If you use 536870912 unsigned (please never use a +-sign in Mobiflight when entering a parameter) that means a single mousclick from the left mouse button. But you should not move an encoder with single mousclicks, otherwise you can not fly short distances

You should use the mouse-wheel-parameter. So use 8192 for ON LEFT and 16384 for ON RIGHT where 8192 is the parameter for wheel down and 16384 the parameter for wheel up.

The mouse-parameters are at the end of the event-id-list from your pmdg.
The only signed parameter you may use in Mobiflight is the one for rightsingle mouseclick (-2147483648). If you ask why, try the parameter without the "-".

Many thanks for your kind attention, but I give up, I will go back to 7.4.0 that everything is working.
hug

Sorry, but the handling is in every Version the same