MobiFlight Community Support

Hi to all;

For a long time I have been researching for PMDG 737 home cockpits (components, software, panels etc.). For a start I have a plan to build a similar desktop cockpit which can be seen in the link below.

https://secure.simmarket.com/sim-on-solution-boeing-737-mip-desktop-system.phtml

But I will not use PFD and ND screens. Full list that I am planning to build is: Tam olarak listelemek gerekir ise;

- MCP
- EFIS (Captain)
- CDU Left (Captain)
- 2 X NAV Panel
- FLAP Gauge (with Servo) and flap annunciator leds
- Landing Gear Lever and annunciator leds
- Modification of Saitek Throttle to motorized throttle (with Servo ; also Speed Brake will be motorized)

I am following this forum for a long time. But I dont know how to add some pictures. Because of this I will give you youtube links about last conditions of CDU, NAV and MCP below.

Link for CDU test: https://youtu.be/Xhs3VO2ciDk
Link for NAV test: https://youtu.be/yivJJWMMFlg
Link for MCP test: https://youtu.be/bkLwULAcYKw (Only 7 Segment Displays are connected and tested)

Also I need some help about throttle. In forum I found many post about usage of servo and relais. Colud anyone can help me about wiring schematics of servo and relay (I want servo to be powered when A/T is on; by the help of relay). If so I will be very appreciate.

Hi to all;

You can see the picture of my project below.

Last updates;

- NAV panels: All fuctions (buttons, 7 segments, leds, rotaries) working.
- FMC: All fuctions (buttons, leds) working.
- EFIS: All fuctions (buttons, rotaries) working.
- MCP: All fuctions (buttons, 7 segments, leds, rotaries) except MACH display (there is a blinking "0" ZERO while MACH displays on 7 segment) working.
- GEAR lever and annunciator leds not finished yet.
- Modification of Saitek Throttle to motorized throttle not finished yet.

I have made a test flight last night (MCP picture is below form this flight). Only problem is MACH display (displays the correct value with a blinking ZERO); and VS display (it should be blank but it doesnt).
I will solve VS problem by using two configs as written on the forum. But as far as I examined topics; there is no solution for blinking ZERO on MACH display.

In addition, I am still waiting an help about how to connect servo with relay for throttle levers. Colud anyone help me about wiring diagram please?

Hi to all;

Last update:

Flaps gauge with servo completed but not assembled in its place on desktop mip panel.

You can see the test video from below link.

https://youtu.be/wqLkHtheLdA

Hi

I love your autopilot and would like to build this myself. Do you have any schematics available on how to wire this up and a list of parts that u used?

Hi,
i just saw your video "CDU-test". You have change 2 letters - M & W, W with square does mean WEST direction

hocam merhaba, elinize sağlık şahane gözükmekte. mail adresinizi rica edebilir miyim, yaptıklarınız hakkında görüşmek isterim.

hocam merhaba, elinize sağlık şahane gözükmekte. mail adresinizi rica edebilir miyim, yaptıklarınız hakkında görüşmek isterim.

ertacerden@gmail.com

ertacerden@gmail.com