MobiFlight Community Support

HI Guys, looking at the offset list I see offset 0348 2 x bytes and formation quantity is between 0 - 16384.

I'm using P3D v2.5 with the FSX default Boeing 737-800. I'm trying to get an annunciator (led output) that would turn ON when an amount of ice is detected on the structure.In the config I have used if($>1000,1,0)

It does'nt work. Are there anyone here that has positive experience with ice detection offset?

Thanks Guys!

Trooper

Hi

I get no experience with that offset and system ... So i can give you just techincal support.
***
Offset seem correct ! And used Transform seem correct, too (You say "If Value is bigger than 1000 THEN Set LED to ON.... ELSE LED is OFF.)

If that is not working, please check....
Does the Offset itself support data ?? Run Mobiflight and check the FSUIPC Value of that Config Line.... Whats the Raw Value ??? And does it change if ice codtiton is change ?

If the Offset not support Data then check:
1. Your basic settings : ( Checkmark for Active set ??, Correct Offset in Use.... Correct Size, Typ, Bitmask ? )
2. FSUIPC Up to date (For your version) Looks like this feature come in early 2017 (Cause it´s written in Blue in my Feb.2017 List.... So it was pretty new that moment)
3. P3D Up to Date ? ( I not own P3D ... Are you shure this Offset Data was include in 2.5 ?? Basicly that sounds like a verry old Version Not shure but 3.4 was the last release before 64 Bit System v4 was available i think.)

HI Pizman82, Thanks for your help as always. I have updated FSUIPC to the latest version and will test it tonight. I'll let you know what happen.

Thanks again!