MobiFlight Community Support

Whats the exact problem ??

I see you use PMDG....Note that it get a own Offset for SPD and Mach..... Mach is a decimal float if i remeber right..... So you need a Transform !

Mobiflight only see full numbers... ... A Offset Value of 0,87 is shown as 0 ..... A Offset like 8,7 is shown as 8 for example.

Please read out the offset with your config and check the "FSUIPC Value" ( Shown in Mobiflight connecter right of the Output config)
If this is a decimal like 0,76 for Mach.76 then simply make a transform $*100 ..... Then 0.76 transformed into 76..... And that is now showable on the display !

Note: In Case that PMDG support MACH and SPD on same offset you need two configs and Preconditions to make this working !

Hallo zusammen,
I will set it this afternoon. Btw, I check the Mach at FL 35.

Warm regards,
Herly

Hallo Pizman,

I just try to set it, but what is the pre condition value? If I activate both IAS and mach, the display blinking between mach and IAS, how to separate or devide this function?

Thank you for your help

Correct.... you have to define preconditions in both Display Configs that manage witch config is running at the moment....

Precondition must use the SpeedOffset Value itself.... If it´s below 10 its Mach.... If its bigger 10 then it´s IAS.
Note.... If you make a Transform to show mach in full numbers like 0,76 *100=76 then precondition must multiply, too.... Here the MACH Config must be Less then 1000 instead of less then 10 !!

Please look here in this posting ( and the postings below) this show the full PMDG B737 MCP display settings !
( Just a auto translate of a old german psoting of myself.... Not 100% Actual ( cause Multiply is used instead transform) BUT it should work today too. )

https://www.mobiflight.com/forum/message/5920.html

Ask here if THIS is not help you !