MobiFlight Community Support

I´m looking for offset to use with mobiflight and 737 of PMDG in order to light the led outputs used in LE DEVICES or "butterfly" that shows the status of flaps and slats.

The offset pmdg document and fsuipc document not contain any refference to this device.

How can I program with mobiflight this device?

Thanks!

Hello my friend,

May be you know but did you try offset 6565 and 6566? They are actually for "MAIN_annunLE_FLAPS_TRANSIT & MAIN_annunLE_FLAPS_EXT" under the flaps gauge. You can use 6565 for the yellow leds and 6566 for the green lights in butterfly but the only problem will be yellow and green lights are together on for 1-2 seconds when flaps goes from 5 to 10. but you will see only yellow lights then. However it is not a big problem to me ...

6565 and 6566 are the offsets only for the GS leds of NGX.

I'm looking for those on the AFT OVH too. But no luck until now.

As i know theses Offsets are not puplished by PMDG or FSUIPC.

Like Bennnozgurum suscribe this is the only recoomend posible solution at the Moment. Yes this is not real, but better then a blanked display.

If you got another information or if you want to write a support request to PMDG then tell us youre experience. It would be nice if we found a real Offset for that in future.

I will try to do it using flaps position as precondition.

If i get lucky i tell you guys.

Hi TarsoSousa

I make some trials today and i get some good results. As you said use the flaps position as preconditions and create two output led. One for le flat trans and the other one for le flap ext.
Go to compare and down you have to check apply interpolation to modify the current value. And then you can tell to mobiflight in wich position of flaps you want to see any led on or off.
In the default 737 , le flap trans led goes on between 0 - 410 and 2048 - 4096.

Hope that will help you.

Kamal