MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #28317

hartr.j@yahoo.com

Posts: 5

I have built this 3d printer G3000 TSC (GTN750) to use with the Honda Jet and the TBM930. The .stil files and mobiflight code files both .mcc and the .mfmc file are provided by this site: https://www.stlfinder.com/model/gtc570-waveshare-7-touch-display-case-encoders-for-mobiflight-LISNNy5P/5745033/

1-I am new to setting up Mobiflight. I have watched several youtube videos but remain a bit confused.
2- My module is recognized and firmware was updated.
3- Yes I know the serial number referenced in the "1_device.mcc" file and the "2_device.mcc" are different than my module but Mobiflight indicated that and yes I told it to update to the new Serial number.
4-It is my understanding I can access only one .mcc file at a time, either "1_device.mcc" or "2_device.mcc". Is that correct?
5- Both seem to be pointing to the Longitude TSC functions

If I run "test" or Run I get several RED ! flags indicating a precondition has not been meet.

I believe I need to go to the input tab and for each input device listed, one by one, select the input device as my Module, and then change aircraft type
and nothing else. Is that correct/

Q; Why are there two device files, each a different size for the same 3 encoders?

Q: Can I simple rename this encoders in the .mfmc file or will that effect the 2 device files?

I hope I laid out my situation well so you fully understand what I am asking.

This may make a good video on How to Bring in Device Files and make the required changes to work on your board, with your aircraft.

2023-12-17 18:01