MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #28296

lexussteve

Posts: 4

Hello,
I have built a lighting panel for the PFD and ND using potentiometers and a Nano board to adjust the screen brightness for my Fenix A320 which is working fine.
I am now trying to do the same for the upper and lower ECAM screens following the same principles but these are not working.
The values can be seen to change on mobiflight when turning the pots but the action in not happening in the simulator itself.
I have used the FS2020 codes available in Hubhop and I installed them via the Input Config Wizard in Mobiflight
@10.23 / 0 max 1 min (>L:A_DISPLAY_BRIGHTNESS_ECAM_L) and (>L:A_DISPLAY_BRIGHTNESS_ECAM_U)

I’m a bit stuck here now so any help would be appreciated.

2023-12-16 16:33