MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #28081

EPICfan

Posts: 14

Hi folks,
I have output values that should be shown on an LCD display and that seem to interfere / compete with each other. For example, if value A is causing problems with value B, I can only display value A correctly if I uncheck the box for value B in the "Active" column in the output configs. Setting B to "0" by way of the comparison section does not help. B would set to "0" as an output value and "switch off" / disappear from the LCD screen, but still interfere with A, causing A to flicker or not to appear at all. Is there any way I can achive the same effect as unchecking the box?

Best regards
-shorthauler

2023-09-14 20:40

Message #28129

XPRoberto

From: Hungary

Posts: 65

Hi,
i think preconditions can be a solution.
If the precondition is not met, then that output is deactivated.

----------------------------------------------------------------
Do you know that you can simplify: if($=1,0,1) ?
Use simply: 1-$

2023-09-28 13:29

Message #28132

EPICfan

Posts: 14

Thank you, this works. My mistake was not to space the offsets, so one offset was writing into a neighbouring offset.

2023-09-30 10:54