MobiFlight Community Support

HI,
I am aware my problem is probably rather simple, but after several hours trying to solve it, I am finally crying for help....
I use Mobiflight 9.5, MSFS2020 and an ELEG Mega 2560 R3 board. After following the led tutorial and completing it, I jumped into the switch part. As much as I have tried with different button/switches combinations, checked and rechecked connections I keep on getting in the Debug window the following message "No config found for button: Button (Press)@SN-594-89b", there is a slight variation when I have tried a push button (just to check if the switch was at fault), were instead of Press it says Release. In the Mappings window I have the Switch defined and running. No matter what I select in the ConfigWizard under Input Action or Preset the final result is the same.
My apologies, since most likely I am missing something real basic, but honestly, can't figure what....

Thanks

Hi

If the logging show you correctly the PRESS and RELEASE of the button then your on the right way...
It means ...
1. Your Button technical work and is electrical fine.
2. Your Button is define in Mobiflight correct (/Settings / Mobiflgiht Modul where you set the right Pin and device typ )
3. Firmware works correctly.

Now the Message "No Config Found" just means.... The Button work, but you NOT use it at the moment within a Input Config.
After you create a Input Config line and choose for that button then this message is gone....

Solution:
1. Confirm you use exact THAT button as Device in a Input Config.
2. Confirm you ACTIVATE that config by enable the checkmark on the Left of the Config line.
3. Confirm your in RUN Mode while testing !

Hi,
Thanks for your help! I did oversee the input tab on the main screen!
Anyway, problem solved, thanks again!