MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks! 

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Posts: 4

I am working on interfacing my weather radar panel with Prosim737. Prosim wants a value for the tilt between -15 and +15, of course the pot only gives 0 to 1024. I have used transform before but not to make a number negative.

2022-01-29 20:09
From: ETSI, Germany
Posts: 6010
I not test it myself.... But should no big Deal!

You need to know the Range of Poti .... MF Potis mostly are 0-1024 . HID are 0-64000 or so....
Best way is to Test this out...

Write with a Poti a MF Variable .... (INput Value=@) .... And Read this variable again with a Output Config.
Then you can turn (while in RUN mode) the Poti multiple Times to check where it starts and end.

Lets expect it goes from 0-1023 ..... So 1024 Values.... We need 30 Output Steps....
1024/30 = 34 means "@/34" occure in a Value 0-30
We finally need -15 to +15 So $-15 should do it. ( e.g. Full Left 0-15=-15 .... Middle 15-15= 0 ..... Full Right 30-15=15)

Combined "@/34-15" ( for the 1024 Situation)

May little adjustments are needed.... But it should work basically !
Good Luck !
2022-01-30 08:11
Posts: 4
I'm going to try this. Ive figured up the range I'm getting from FSUIPC logging. I figured it could be done but i wasn't sure how to write it.
2022-01-30 18:35
Posts: 2
I can't make it work, :/ I have the values on Flight Sim Value y Output Value from -15 to +15 but no change on the prosim pedestal, is there something I'm missing?

2023-11-03 23:22