MobiFlight Community Support

Hi, i have managed to find the variable for the ir and adir led to indicate if it is on/off, however it does the opposite, so when the button is on, my led indicated as if it was off, i wondered if there is something i could do to flip the led action?
If that makes sense any help would be great thanks

Hi

Without deeper view i can not tell you what is wrong here..... So if the "Offset" or the "Variable" is simply wrong or if you did a mistake in the Config syntax.

Basically.....
A LED is ON if the "Output Value" of Mobiflight is NOT 0 ..... So "0" ZEro means OFF .... Every other Value means ON.

To find out..... Please check the Mobiflight Connector Window..... On Output Tab observe the Collumn right of your Config line.... FSUIPC Value means the raw Value we read from the Sim..... Output Value means the Value we "export" to the Device ( LED in your case).

May you see a issue here ! Or you can see/understand why the sim e.g. gives you a "0" when it should be ON and a "1" if it should be OFF. (Can happen on Multi Switches)


Solution:
Use the COMPARE Tab or a Formula in the Transform Line !

E.g. If LED must be ON aslong Raw data is "0" and OFF aslong raw data is "1" or greater ....
Then say Compare : If Value = 0 THEN 1 ELSE 0
Or use a formula in transform like if($=0,1,0)

In easy words.... You must know what you expect..... You must figure out how the raw data work..... And you finally tell mobiflight how it should "change" the Value.