MobiFlight Community Support

Hi.
I have tried to set up a 3 digit 7 segment to show the trim setting.
When testing all three digit and DP show correct.
As soon as I start the application it shuts down and in log it says "Error on config exec. Input string was not iin correct format.
I have used Pizmans setup in message 1791 for the transform: Round(($+5000)/1265),2)*100
What am I doing wrong
HenningR

Hi Henning,

if you write your formula like here it is wrong.

Round(($+5000)/1265),2)*100

You have two bracket open but you close 3, so the Round area is closed before the comma

Round(($+5000)/1265)

the ,2 is out of the Round area. So leave the bracket after 1265.
I use a similar formua: ($+5000)/12.65 - makes the same

Thanks Stephan
I have now tried both and it now says :"Problem with transfer an error occured on parsing value formula pls review and correct errors
Round(($+5000)/1,65)
and
($+5000)/12,65
I have used the same setup else as in message 1791
Offset 0BC0 int 2 BCD mode 0xFFFF
Red asterix with text: Error on config exec. Input string was not iin correct format
Do yo use point . or comma , in the formula I have tried both with the same result
MF says Flight simulator value 52 and output on display 3.99 but show on 7 seg. 3.33
HenningR

I have now tried both and it now says :"Problem with transfer an error occured on parsing value formula pls review and correct errors
Round(($+5000)/1,65)
and
($+5000)/12,65

Decimal and Point Issue !!!!

A Decimal number (Float) is always written in a Syntax with a POINT ..... So 1,234 is WRONG ..... 1.234 is correct !

Simple rule:
POINT"." is used for Decimalnumbers like 1.23
DECIMAL "," is used for syntax functions like if(a,b,c)