MobiFlight Community Support

Hi,

I have connected 7-segment LED to my Arduino with Mobiflight.
I can display the COM1 value except, I only see 5 digits (123.45) and in the Radio Panel in MSFS2020 I can read 123.450.
When I turn my rotary encoder it move 5 by 5 and I can see it in my screen but no in my LED segment.

Is it a way to display all digits with MobiFlight ?

I have shared the outcome of this integration in that YouTube : https://youtu.be/FvCtjpQYWzI

Thanks

Hi vperrinfr,

Welcome to MobiFlight!

That can be ok and is denpendig of the offset you use. Which offset do you use? 0x034E or 0x05C4?

Hi all, my first contribution here
This is for MSFS2020 :
For COM1 Active, use offset 05C4
For COM1 Standby, use offset 05CC
For COM2 Active, use offset 05C8
For COM2 Standby, use offset 05D0

Tested and approved.

Thanks for you reply.
As of today, I use "Preset" dans the Offset value is 0x034E.

When I want to change it to 0x05C4, I have an error "Error on config execution".
Do I have to change something else ?

Thanks

In my config for COM1 Active, i have the following values
Offset : 0x05C4
Value Type : INT
Size in bytes : 4
Mask value with : 0xFFFFFFFF (<- 8 F's)
BCD Mode : check

I think it's the size who matters

Great.. it works, but I have found a new issue.

In MSFS2020, Value = 124.850, in my LCD I can see 124.860

Found the problem. I had Transform box check with the value "$+10000", I changed it to "$" and it works now..

Thanks

In the transform box you do not need a single $. If you do not want to change the value you can uncheck this line