MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #18209

Ridgeandgable

Posts: 131

hi guys

Can we use Pin 0 & 1? or do we start from pin 1 (tx)

2020-04-05 17:18

Message #18211

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

No Official Statement....

But we recommend to NOT use Pin 0 and 1 .... Start with Pin 2 !!!!
Also not use AnalogPins whatever they are already implement since last patch.. Lots of User report Bugs there... So not use them until problems are solved !

Good Luck !

2020-04-05 17:27

Message #18217

StephanHo

Moderator

From: EDDG, Germany

Posts: 1867

Supporter

Addendum:

You can only use the pins from the drop-down list and pin 0 and 1 are not in there

Pin 0 and 1 were internal used to upload the firmware and the devices. These pins are TX0 and RX0 for a serial interface.

Grüße,
Stephan (Time: UTC+2)

2020-04-05 20:42

Message #18221

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

Shame on me.

Did Sebastian remove that ??? If i remeber right in my First days while using Mobifligh, Pin 0 and Pin 1 was on that list. Never check if this have changed

Whatever.... Problem should be solved !

Good Luck !

2020-04-05 23:46