MobiFlight Community Support

Hi at all!
I have an Arduino Mega correctly connected with MF!
I open FSX and after MF.
If i try to insert in InputConfigWizard the correct code to Switch ON LDG Light, it work!
Else if I insert code taked to this website http://fsuipc.simflight.com/beta/Offset_Mapping_PMDG737NGX.pdf
when I open my 737-800 and put the switch it don't work!
Know you the problem??

Thankyou so much!!

Hi,
these offsets for the PMDG 737 are read only (outputs). I recommend you to use Event Id's für Inputs, it is easy to configure and it is working realy good.
At the input page of Mobiflight set send Key instead of FSUIPC offsets, and follow the instructions below.
http://www.myhomecockpit.de/index.php/en/tips-tricks/pmdg-event-ids

Hi Fusa thankyou!
I have try to configure with key and it work!
But is possible take the code to EVENT ID's Document, as Event ID 69742 and SDK Value 110 and insert in MF??
I don't want use the keybord button because there would be too many steps!
I prefer work with a light programmer! =)

I know it is possible right now to trigger Event ID via FSUIPC offset (0x3110).
When you want to supply an additional parameters you can try to combine the two values in the different 4bytes into one which results in a very large number. If you are familiar with bytes and addresses this should be possible to understand, of course it is not user friendly. I have not yet tried it out.

I therefore plan to explicitly support EventIDs in the near future.

You can also try to duplicate the config for your button. One for Offset 3110 and one for 3114. In the first you put your EventID (4byte) and in the second the SDK value.

These would then be both executed when you use the button. It might work, I have not tested it.

Hi Sebastian!
I try with 3110 and event is recognized to FSUIPC! In Console Log Event Report 69743 but the Param is 0, when, if i try to put down the light param is
Param= 4194304!
At the first time MF Have correctly work after 5 min is crashed all!!! MF,FSUIPC,FSX
Whi??

I am very optimistic to publish the next 6.3 release tomorrow with explicit support for Event IDs.

You are the best!! Many thanks! It will be a very big option! I tomorrow try this release and riport here if and how work event ID!
Thanks again!!

Released! Awaiting your feedback

I've try but i have problem..
I don't know how configure MF for PMDG, sorry but I'm not expert in FSUIPC!!
For example:
Light_L_Retract SDK VALUE: 111 EVENT ID: 69743

I have try to insert 0x3110 in Offset, and 69743 in value!
but.....after ???what do i do??
Theanks again!!

AHAHAHAHA!!! SORRYYYYY!!!!! I don't have look section ID EVENT!!!
For all which have the same problem, in "Action Type" Select Event ID a preset or value of PMDG Event ID Document!

Thank you very much for this program!=)