MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #12232

richard.long

Posts: 8

Hi all,

I have run the PB tutorial and have the problem that the output is the opposite of the parking brake state. I.e.

PB ON = LED OFF;
PB OFF = LED ON

The LED is also ON at all other times when the Arduino is powered.

Did anyone else encounter this and have a solution?

Thanks

2019-03-20 12:26

Message #12237

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

Thats Not Correct.

There must be a Issue in your Wire work OR In Your config OR in your Workaround of Using the MF-Arduino System at all.
NOW the other Problem with your relais from different topic also makes sense... We have a "Problem" , Houston !

For Testing:
1. Confirm your LED is NOT at Pin 0 or Pin 1

2. Please Confirm problem is still there after a complete RESTART.
Dissconnect Arduino from USB .... Close MF Software ..... Wait 10 Sec .... Reconncet Arduino .... Start MF............ Problem still there ?

3. Run MF and SIM in ADMIN MODE

4. Confirm Your electrical Setup. Any Diodes there.... Maby LED set iverted ? GRD and/or 5v is used from Arduino ? If Eyternal Power is used... Is it correct implement.

5. Confirm your Device Settings.
Get sure that you have not multiple Devices on the same Pin...

Good Luck !

2019-03-20 13:22