MobiFlight Community Support

Welcome to the forum for MobiFlight! Feel free to reach out to the community in case you have questions, issues or just want to share great ideas or details about your latest home cockpit project.

You like MobiFlight? Donate via PayPal and support the MobiFlight development. Thanks!

05/03/2024 - This forum is read-only

The community support for MobiFlight has moved exclusively over to our Discord server. Register for free and enjoy more interactive functions like image and video upload, voice chat. More than 7,000 registered users around the world make it a great experience!

See you on our MobiFlight Community Discord server.

A HUGE Thank You to everyone who participated in the forum, especially obviously to Pizman and Stephan who did an outstanding job over so many years providing an incredible service to the MobiFlight community.

The forum is still providing a lot of good content, hence we keep this information accessible.

Message #11576

Paride737

Posts: 13

Hi Boy, I'm trying to configure the flap indicator servo with Mobiflight only that the offset I enter is not the right one. Do you know the offset to be included in mobiflight for the Zibo 737-800 aircraft in Xplane?
Thank you
Paride

2019-02-08 10:02

Message #11594

pizman82

Moderator

From: ETSI, Germany

Posts: 6010

Supporter

Hi. Pretty sure this not exist !

Zibo is a AddOn.... And XPUIPC "normaly" not include Datarefs from Addons.

If you like to use all Zibo functions you must find out whitch are included (Standard Stuff) and all others must be reworked by yourself ( written in the XPUIPC File )

In the Flaps case you maby be lucky. check the Flap Offsets Standards . For Example 0BE0 4 Byte (Left Flaps) 0BE4 4 BYte (Right Flaps)

If zibo also controll the Standard Flaps ( nearly 100% sure) then you can Read this value and use it.

In that case run your flaps and observe this offset. Figure out what value is there on Flaps 0,1,2,,5, and so on until 40 )
Finaly you can use this values fpr the Stepper Config via INTERPOLATION !

Good Luck !

2019-02-09 04:02