MobiFlight Community Support

hi there
thanks for the new version i downloaded it and start again with the radio again. after i done all the settings, upload it to the
board and check again the settings was lost again. what can it be can you help me because im really confused.is it something
im doing wrong i build my airbus sim and used arduino code but now i want to change it to the 787 with lcd but it is not working
is there any sofware that i need to run but i think i have all installed.i want to upload some pict but dont know how to do it

Need more details about your hardware and setup. Did u use MF 7.5.1. Also please clear the mega eprom first before upload new firmware. Then upload ur hardware setup, then run ur config. Remember there certain limitation of hardware u can use. Good luck.

hi there how can i upload photos to show what i done thanks.

Yes. You can upload pict to free websites, like imgBB or tinyPic , then use the pict insertion icon , the one above , it should be like this '[ img]yourpictURL[ /img]' . YourpictURL is the link to your pict given to you from the website to share. Good luck.

Also try to trouble shoot by testing your setup part by part. For example, setup LCD first , make sure they display correctly . Then setup 1 or 2 buttons only , make sure they work . Then setup additional encoders , make sure they work . Then finally put all together . Good luck.

hi there
after i done all the settings, upload it to the board and check again the settings was lost again.

????

The Problem in the past was, that Settings of Placeholders (in the Config) was lost after you save it and restart mobiflight !

THIS Bug is solved with new version as i know ( Not try the release till now but in Beta that was fixed.

I not understand WHAT you Upload to the board here. The Hardwarepart ( Device on Arduino) is the same like before ! Nothing need to be uploaded !

hi there
i have 2 arduino uno and 2 mega cards. i have run my radio arduino code on the both uno and it is working fine.
now i start mobiflight and i have to upload the mobiflight firmware to the cards. its doing it because i can see the lights
on the board is flashing till the upload is done .firmware upload successful.now i run the com1 on mobiflight and all done .
now the lcd do not show anything but when i do the test the lights on the board flashes but no response on the screen.
i tried it with the 7 segment led and also the same no display on it . im working on w7 32 .thanks help much appreciated.
i just dont get any display output on the lcd or 7 segment.

It been repeated many times that arduino uno not supported and there problems with them. Can you test with only arduino mega and disconnect uno for now. Good luck.

i have 2 arduino uno and 2 mega cards. i have run my radio arduino code on the both uno and it is working fine.

As thatchi said... UNO is not longer supported since 2 Years ! Please read the Stickys here in Forum !
We not remove Firmware and possibility to UNO cause some things are working and "older" Users still use it. BUT we not build new stuff ( Like LCD) for UNO and we not test it anymore. ... So "Maby" a feature work... "Maby" Not.

I Recommend to use MEGA only.... If you use UNO its your problem to find out if the issue is the UNO itself !

*****************

About the other thing.... WHAT is a "radio arduino code" that you use on your UNO before ??

I know translating is bad and my english is not the best finaly.... BUT You need to explane so stuff more detailed ! We can not see your system. We have no screenshots.
so we must understand the problem just by your description.... So please try to give us a better information !